-
CLICK HERE for more information or to Shop online.
- Wet Wedge Soft Block 5 inch
- 2 1/16" 0-1600 psi Sport-Comp NOS press gauge(E)
- 3 3/4" 8000 rpm pedestal mount Phantom tachometer
- 90 degree fitting for press gauges #4 S.S. line
- Outer Sheath for Hanging & Bench-Top Motors
- Powdercoating 4 Tapeinstruction Video'S & Handbook
- Battery Shut Off Switch Fuse Link
- Buff Shop Kit With 1 And 1/2 hp Motor
- Oxy Acetalene Shank for Henrob Torch
- 8" Stainless Steel Locking Ties (8 pack)
 |
Removefrozen brake drums without damaging the drum! Just tap lightly with hammer on jaw ends to release drum. Not to be used as a "puller". |
 |
Introduction to Restoration Video - Here's a 2 hour 15 minute two VHS video set that takes you through the entire restoration process. Full of tips, demos and visits with pros. Includes five main categories; Body, Engine, Paint, Interior and Trim. Highlights cutting worn piston ring grooves with a machinists lathe, body panel overlapmethods, setting timing w/valve lift, paint tricks, redying leather, using precision measurement instruments, re-veneering interior wood, matching carpet edges, glass beading, cutting out panels, two tech sessions, a detailed explanation of the entire chrome restoration process and tons more! |
 |
Corrosion-resistant steel tubing like OEM on most cars. Use with our tubing bender(49002) and flaring tool(49001) to create replacement or custom lines. Includes.028" thick wall tubing, 6 master cylinder fittings, and 10short wheel cylinder fittings. For SAE doulble-flare applications. |
 |
Increase the capacityof your PRO HotCoat Gun with this new adapter kit. Holds 8 times the capacity of the gun cup. This kit is used with the (10298) HotCoat Hopper System. |
 |
Original style Chrysler Rallye Wheel with large bolt pattern as used on Moparvehicles. Quality accurate reproduction of the original. Wheel size is 14"x6" with a 3-3/4" backspace. Configuration is 5-lug with a 4.5 inch bolt pattern. Compatible with disc brake applications. Made in the USA. |
 |
Includes25' of Protect-A-Wire, 24 Hi-Temp Shrink Tubes and 8 Protect-A-Boots. |
 |
Metal gun with 20 oz. acetal cup. Includes a 2.2 mm fluid tip, gun lube, filter, and instructions. Sprays heavy lacquers, enamels, primers, urethanes and water-borne coatings. Requires12.5 cfm at 23 psi for 10 psi at the air cap. One-year manufacturer's warranty. Made with domestic and imported parts. |
May we also suggest the following products:
