-
CLICK HERE for more information or to Shop online.
- Hotcoat Powder Corrosion Resistent Primer - 8oz
- Buff Wheel 8 Inch Canton 1/2 Inch Hole
- Hotcoat Powder Rally Wheel Silver 8 oz
- Buff Motor 3/4 hp 1800RPM
- Rubberized Undercoating Aerosol 18.3 oz
- 2 1/16" 140-280 F Ultra-Lite water temp gauge(M)
- Cool Tube Extreme 1/2" Black - 3' length
- Auto Probe Portable Infrared Thermometer
- 2 5/8" 0-100 psi Carbon Fiber oil press gauge(E)
- Petting Stencil Curse of Skullmaster
 |
Cold Galvanizing Compound is formulated of 90% Pure Zinc. It chemically fuses to bare steel forming a permanent barrier. Even if scratched, the zinc will deter rust from starting. Acts as a great weld-through coating: ideal for treating the inside surfaces of new replacement body panels which will not be painted, but need superior, long-lasting protection from rust. Not to be used asa primer or painted over. Repairs galvanizing. Buy 3 or more and SAVE! |
 |
FACT: Over 80% of all engine wear occurs when an engine is first started. But did you know that "Dry Start" wear will be eliminated by PreLubricating your engine. Never pull a distributor again, never "Dry Start" an engine again. With the easy to install MasterLube (Electronic) you can prelube your engine in just seconds before every startup, then the System automatically refills itself for the next cycle. Permanently mounted. Just press a switch to activate. Can alsobe used as an accumulator for racing applications. |
 |
Never Change Points Again - The Ignitor from Pertronix takes the place of standard points and fits under the stock distributor cap. Installs in about 15 minutes! Provides a 2:1 improvement over "point type" systems. Experience reliable ignition performance in all weather and rpm conditions. Increases horsepower, fuel economy and spark plug life. This proven technology has been used in race cars, off road vehicles, back yard mechanics and more for over 25 years. Legal in all50 states and Canada (CARB E.O. #D-57-2). |
 |
2 1/16" 0-60 psi Z-Seriesboost gauge(M) |
 |
Stop Using Wire Brushes. Sick of discovering wire bristles in your favorite sweatshirt? Now there is a better, longer lasting, safer alternative. The 3-M Radial Bristle Brush is made from a plastic like material that's uniformly impregnated with abrasive. As the wheel wears, fresh abrasive is exposed to assure consistent cutting action. Includes push-out sleeve adapters to fit motor shafts from 1/2" to 1". Six inch diameter 8 ply wheel with1/2" face Maximum RPM 10,000, Green (50 Grit). Great for removing rust and old finishes |
 |
The 1 1/2 HP 3600 RPM motor with 7/8" shaft comes with the buffing cabinetwhich is great for storage. |
 |
Carb Renew - Restore the OEMlook found on just about any carburetor. Carb Renew is a translucent acrylic enamel that is resistant to fuel and most additives. (Please read and follow label instructions carefully.) While your carburetor is apart and all jets are removed, simply spray Carb Renew on the exterior of the thoroughly cleaned bowl cover and main body. Produces a natural 3-8% gloss. Carb Renew is supplied in a 5 oz. net wt. aerosol can. Enough to cover 2 sq.ft. |
May we also suggest the following products:
