-
CLICK HERE for more information or to Shop online.
- Welding Helmet Adjusheadgear w/#10 Lens
- 2 1/16" 240/33 Ohms Phantom fuel level gauge(E)
- Top Dead Center Indicator w/extension
- Evil Horde Curse of Skullmaster Series
- 2 1/16" Boost-Vac 30InHg/20 psi press gauge (M)
- Trunk/Floor Repair Kit
- Motor Adaptor 5/8 Inch Right Hand Thread
- 2 1/16" 0-100 psi Ultra-Lite oil press gauge(M)
- 2-5/8" 100-250 F Sport-Comp oil temp gauge(E)
- Cold Galvanizing Compound Aerosol 14 oz
 |
The 1 1/2 HP 3600 RPm motor comes in this kit which also includes, 6compounds, 2 each of the 10" buffs w/ 3/4" hole, face shield, dust mask, gloves, buffing instruction booklet and "The Art of Buffing" video. |
 |
Struck by a Lite'N'Bolt. Lite 'N'Bolts are illuminatedstainless steel mounting bolts that can be used in a multitude of locations on your ride. A trick alternative to standard license plate bolts, dash lights, or even auxillary map lights. Kit includes 2 Lite'N'Bolts. Easy to install. Made in the USA. |
 |
Hole Size:2-1/16" |
 |
Don't get black-flagged in the pits for excessive speed! Driver-controlled device assists in keeping a safe speed. Set light for an rpm just under the limit, green LEDs flash when limit is reached. Or set device just over the limit, triggering red LEDs. Mount right on dash in clear driver view. Requires switch to activate speed window andTach Set-Up Module (item No. 75083) or tach signal to set RPM window. |
 |
This Eastwood Complete Manual Transmission Kit includes all necessary bearings, seals, gaskets, synchronizers, springs, and bushings needed to rebuild your Borg Warner/Tremec 6 speed, used in GM Camero and Firebird from 1993 thru 2000. Not for T56 used in the Corvette from1997 thru 2003. A detailed exploded view is included. Factory shop manual suggested - professional installation recommended. Made in the USA. |
 |
Protects wiring, fuel lines, brake lines, etc. from heat up to 750 degrees F. Combines flexibility with maximum thermal protection. Can be easily slit to install on existinghoses or wires. |
 |
Underhood Black is the correct shade of black, having just the right 10-20% semigloss finish most car manufacturers used on radiator supports, inner fender walls, lug wrenches, jack bases, underhood brackets, and other parts. Hardware store black paints are either too thick, too glossy, or the wrong color. Just clean, degrease, and prepare the parts well, then spray on for a "factory-like" finish. This acrylic lacquer withstands up to 250 degrees F and goes on thin for a satin smooth finish which does not hide surfacedetails. One gallon covers 192 square feet. Thin 100-150% w/lacquer thinner or Xylene for spraying. |
May we also suggest the following products:
