-
CLICK HERE for more information or to Shop online.
- 2-1/16" 0-1600 F Carbon Fiber Pyrometer gauge(E)
- Buff Motor 3/4 hp
- KOSMIC Kolor Thinners High Gloss Gallon
- Buff Motor 3/4 hp 1800RPM
- 2 1/16" 140-300 F Ultra-Lite oil temp gauge(E)
- 3 3/8"160 mph in-dash w/odometr Pro-Comp speedo(M)
- 2 5/8" 30 in vac/20 psi Auto-gage boost gauge(M)
- Painters Nib Files Set Of Three
- 2 1/16" 30InHg./15 psi memory Phantom bst gauge(E)
- Funkadelic Stencil
 |
One 2 lb spool of.035" Flux CoreWire. |
 |
Includes 6 ft. nylon tubing and 1/8" and1/4" NPT fittings. |
 |
TheReplacement Filter for the Moisture Separator restores the 34103 separator to like new. For best results mount the separator as close to where the air is actually used as possible. |
 |
The Anode supplies metal ions to the solution for plating. TheAnode slowly wears away during plating and eventually needs to be replaced. Clean the Anode Bar after every few minutes of plating to remove the dark buildup. (Use an old toothbrush & distilled water). DO NOT CLEAN BAR WHILE IN THE PLATING SOLUTION. Use Replacement Electrolyte Solution (10049 ZB) to replace contaminated solution or for plating larger parts. |
 |
When serious engine builders "blueprint" an engine, they'll "port" or smooth off rough head castings around the intake and exhaust ports for betterair flow. This makes it easier for the engine to "breathe" resulting in greater power and efficiency. Using the Porting Kit, you can perform this professional technique at home. The Porting Kit contains 80 grit abrasive rolls: 20 tapers for reaching into tight spots and 20 cylinders for flatter areas, two 4" and two 6" mandrels, and complete illustrated instructions. For best results use a high speed grinder. To remove more, try carbide burrs. |
 |
Drill Set for Hardened Steel - Drilling drilling broken studs, spring bolts, die sections, broken easy outs, extra tough metals, exotic metals, brake drums etc. isn't easy without the right bits. This set of 1/8", 3/16", 1/4", 5/16", and 3/8" drills will cut hardened steel in the range of 48 to 65 Rockwell "C". Works best with heavy pressure and low RPM with cutting oil, in a drill press, but can be used in portable drills. Drills supplied in a durable metal case. Imported. 30 dayEastwood warranty. |
 |
Renew or change the color of your vinyl upholstery and plastic surfaces - permanently. Flexibleenough for seats, yet tough enough for vinyl tops. For optimum results and adhesion, use Plastic Prep and Sand Free-Kit on hard plastics, and Vinyl Prep on vinyl. Buy 3 or more and SAVE! |
May we also suggest the following products:
