-
CLICK HERE for more information or to Shop online.
- Wet Wedge Soft Block 5 inch
- Rocker Arm and Lifter Tray for Eng Rebuilding
- Exhaust Pipe Expander
- 2 5/8" 0-15 psi Phantom fuel press gauge w/isol(M)
- Chrysler Rallye Wheel - Large Bolt Pattern 14x7
- Pertronix Flame Thrower 40,000 volt Chrome 3.0 Ohm
- Motor Adaptor 5/8 Inch Right Hand Thread
- Eastwood 1/3 HP Buff Motor
- Soft Lifter Jack Pad
- Hotcoat Powder Gold Vein 8 oz
 |
You've detail-painted your vehicle's components. Now spend a few moments to protect your work. Detail Clear utilizes a special low-sheen formulation that won't offset the "soft" OEM-like finishesof detail paints. It dries fast and resists fading, chipping, cracking. Compatible with most thoroughly cured enamel and lacquer paints. Buy 3 or more and SAVE! |
 |
Sound Control - Quiet in a bottle. Spray on vibration/sound dampening coating makes the interior of yourcar quieter, and enhances sound system performance. One quart container coats up to 15 square feet. Sprays with our (16030) Air Undercoating Gun with Bottle. Easy water clean-up. |
 |
TOURING cover in grey, fits largest size touring motorcycles, 1100CC andup, equipped with fairing, windshield, mirrors, saddle bags, sissy bar or backrest, travel chest, light bar. Covercraft's Pack-Lite WeatherShield Cover is weatherproof, breathable, UV resistant and dustproof. Just shake the cover and it dries in minutes. It packs light and folds compactly. |
 |
The 3/4 HP 3600 RPM motor with 3/4" shaft workswell on this cabinet. Great for storage!!! THIS ITEM MAY TAKE 10 DAYS TO 2 WEEKS FOR DELIVERY |
 |
The easy way to restore that showroom appearance to old or neglected cast iron manifolds, these kits are used with your high-speed die grinder to level rusted pitted surfaces. The Standard Kit consists of twenty 80 grit abrasive cylinders and ten each of 80 grit tapers, 120 grit cylinders and 120 grit tapers. Two mandrels are also included. The Deluxe kit adds a carbide bead burr for faster cutting, to remove casting flash or shape the metal for a custom look. After metal issmoothed, apply one of our high temp. coatings. Your rust-prone manifold will keep that new look for years. Instructions incl. |
 |
Fabricate double-compression lines (brake) or single-compression lines (fuel, etc.) in steel, aluminum, or copper. Not recommended for stainless or tubing walls thicker than 0.040". Handles 3/16", 1/4", 5/16", 3/8" and 1/2" O.D. tubing. Limited 1 YearManufacturer's Warranty. |
 |
Hotcoat Powder Arch. Bronze5 lb |
May we also suggest the following products:
