-
CLICK HERE for more information or to Shop online.
- 94 Minute VHS Instructional Video
- Metal Cutting Saw Blade
- Kustom Painting Secrets-VHS
- 10 Gauge Red TXL Wire (25 ft.)
- Reducer Bushing M10x1.5mm
- Motor Adaptor 5/8 Inch Left Hand Thread
- Color Match Cards
- Round Hole Punch 3/4"
- Flexible And Semi Rigid Sanding Block Kit
- Hotcoat 3-Tier Powder Rack
 |
All HotCoat Powders are exclusively formulated for the HotCoat System. They are optimized to promote static charge for uniform coverage and finish. All are UV and fuel resistant. Packed in8 oz. net wt. cans. |
 |
WheelChock - For trailer, shop, truck or anywhere you need to secure your bike. Bike is held in a vertical position by locking either front or rear tire, simply roll bike into chock and secure by tightening the hand wheel. Constructed from 7ga steel plate, 3/4" alignment shafts and a precision acme lead screw. Holds any bike with tires up to 12" wide securely and safely. Mounting slots are provided in base to accommodate any type installation. Made in USA. Two year Mfg. Warranty. |
 |
Undercoat removal made easy! Here's the solution for undercoats thatcan be imprinted with a thumbnail. Biodegradable undercoat remover quickly loosens the bond of the undercoating to the base metal and allows you to easily scrape it loose. Use PRE Painting Prep to remove any remaining residue for a "paint ready" surface. Not for use on baked-on, epoxy or urethane undercoatings. For cleaning up an area to be welded, this is a must! 17 oz. net wt. aerosol. |
 |
KO-SEAL II is a two component acrylic urethane primer sealer. KO-SEAL II has two series of products: One series meeting the VOC requirements for National Rule and one series meeting the VOC requirements for SCAQMD Rule 1151. Please choose from either Quart or Gallon. Refer to House of Kolor technical guide forproper mixing and handling procedures. This product cannot be applied over bare metal surfaces of any kind. Ko-Seal II must be applied over sanded and clean primer or properly prepared and sanded previously painted surfaces for proper adhesion. |
 |
Includes7' of Protect-A-Wire, 6 Hi-Temp Shrink Tubes and 2 Protect-A-Boots. |
 |
SHIMRIN Neons (NE) are universal base coats that may simply be cleared for a final finish, or used as a base coat for Kandys or Pearls. Due to their unique chemistry make-up, they may be top coated with either acrylic lacquer or urethane enamel. Neons are designed for high visual impact onracecar, boats,cycles, etc. Note: USE WITH DISCRETION!! Neons have limited lightfastness in the sun. Neons are not recommended for overall refinishing or where long life is a requirement. Neons are usually applied over 8513ZP Shimrin White BC-26. |
 |
ForAdapting Oil Pressure and Temperature Gauges to Most Foreign Cars. 1/8" NPT to 1/8" BSMT |
May we also suggest the following products:
