-
CLICK HERE for more information or to Shop online.
- Super Plus Oxisolv Rust Remover
- Square Drive-to-Drill Chuck Conversion Set
- Tubing Flaring Kit ISO Set
- Single Fuel Tank Stand
- ATD 7in 1000/3000 rpm Shop Polisher
- 2 1/16" 240E/33F Design Blk fuel gauge red needle
- Infrared Replacement Element
- Liquid Electrical Tape Black 4 oz
- 2 1/16" 30InHg./15 psi memory Phantom bst gauge(E)
- 8PC 1/2inch Drive Wheel Nut Impact Socket Set
 |
This 3/4 HP 1800 RPM motor with 3/4" shaft is single phase, 60hz and requires amps at 115 vac or 2.3 amps at 230 vac. Use with our 10" buffing wheel with 3/4" arbor hole. Overall shaft length is about 28" distance from the housing to end of shaft is about 6 1/2". Motor is protected by a 3 yearwarranty. |
 |
Rock the competition or shake up the street with Ultra-Lite electric gauges! The perfect option for those who want to avoid routing steel braided lines and copper tubing. Simple to install and boast the same solid accuracy and smooth pointer movement as other Auto Meter gauges designed for racing. Ultra-Lites look especially sharp when used with mounting accessories from Auto Meter Gauge Works. Includes 1/8" electric sender,may require drilling to tap threads into cylinder heads. |
 |
Features anodized blue exterior, and many unique features specifically designed for sprint cars and other forms of racing. The luminescent dial glows at night for dimly lit tracks when no battery is available to light up conventional gauges. A sealed, water-resistant case keeps moisture and debris out for easy cleaning. These gauges are for racing purposes only, and willnot operate properly in a street driven vehicle. (6 ft. capil.) |
 |
You can remove all vinyl pinstriping,graphics, and adhesive residue without damaging the paint. Simlpy mount the eraser in your air drill (recommended speed is 3,500 to 4,000 rpm.) and safely remove all the old body striping in minutes. Unlike chemicals and solvents commonly used for this job, the soft wheel is gentle to the finish. Not recommended for acrylic lacquer or plexiglass. |
 |
Infrared Cure System with PRO HotCoat Gun Deluxe Kit (58130) - This kit gives you everything you need to coat and cure small or larger parts. The following items are included inthis kit: PRO 1100 Gun, 2 lbs. Gloss Black Powder, 20 oz spray bottle ofOxisolv Rust Remover, Metal Wash, a roll of 1/2" and 1" High Temp Masking Tape, 1 lb spool of Stainless Steel Wire, PRE Painting Prep Aer., Set of 3 Gun Cups and Lids, Disposable Moisture Filter, Infrared Light, Light Stand, IR Thermometer, and complete instructions. NOTE: GROUND SHIP ONLY! |
 |
Just connect the gun to your 7 cfm at 80 psi compressor put on appropriate protection and put the pickup tube in a container of blast media. The Heavy- Duty die cast gun includes a steel nozzle for small compressors. The Suction head draws the abrasive grit into the air stream to minimize surging or skipping. Trigger action lets you blast whenand where you want. Upgrade with larger nozzles and air jet for faster performance. Includes gun, 10' hose, 3 spare nozzles, pickup tube and instructions. Be sure to wear all appropriate safety equipement. Imported. |
 |
2 1/16"100-250 F Z-Series trans temp gauge(E) |
May we also suggest the following products:
