-
CLICK HERE for more information or to Shop online.
- 1968-69 Chrome Whl Mustang Torino Fairlane 15x6
- Gas Tank Sealer One Pint 16 oz
- 35 pc Torx Bit Master Set 3/8, 1/4 Drive
- Trunk/Floor Repair Kit
- 3M Hookit Film A10 Medium Blue 5" Diam.
- 2 1/16" 0-100 psi oil press gauge(E) blk needle
- Nozzle Ceramic Set 1/4 Inch
- Hot Coat Grey Metallic 8 oz
- Touring Cycle Cover Large Cruisers 1100cc - 1500cc
- 2 1/16" 240E/30F Old Tyme Blk fuel gauge blk ndle
 |
Helps make your tools safer and more comfortable to use. Bonds to metal, wood, and most other surfaces. Just dip your tools and let them air dry. Won't chip, crack orpeel under normal use. Flexible from -30 to +200 F. Acid and salt water resistant. NOTE: This item cannot be shipped by air. |
 |
Engine Primer - Most engine wear occurs when an engine is first started. Whether you're starting up an engine for the first time or after extended storage, here's an inexpensive way to prelube your engine. Aerosol dispenser with 29" hose and fitting with 1/8" NPT thread attaches to most oil sending unit ports. Injectssynthetic oil blend. |
 |
Underhood Wiring Dress-Up Kit - Prepackaged kits include enough flexible convoluted polyethylene tubing to dress up the engine compartment. Each kit includes 10 feet of each of the following sizes: 1/4", 3/8", 1/2", and 3/4"Apply Kopre-Shield (25002) to wire connections to prevent corrosion. |
 |
The most important tool to any pinstriper is a good striping brush. Hand made of choice 100% camel hair. Ferrules are treated with special adhesive to keep bristles from pulling out. Round handle lets you easily roll the brush on tight corners. The 2" bristles load wellfor long lines. Brushes come in plastic storage tubes. Stripes in six sizes from 1/8" to 1/2" wide. |
 |
Gets into pits and slightly irregular surfaces. Great for cleaning the edgesof body panels. Works great with your electric drill, too. Maximum speed: 5,000 rpm. Larger work area than typical 4" diameter wheels with 50% more abrasive material. |
 |
Apply liquids, degreasers, lubricants, rust preventatives, andpaints with the Pre-Valve Aerosol Sprayer. Fill the 6 oz. container 2/3 full, screw on the 2.1 oz. pressurized propellant can and spray. One propellant can will spray up to 16 fluid ozs. |
 |
HotcoatPowder Semi Gloss Black 2 lb |
May we also suggest the following products:
