-
CLICK HERE for more information or to Shop online.
- Hotcoat Powder Silver Hammertone 5 lb
- Protect A Boot XL 8 Inch Silver 2 Pack
- BONZ Template
- Cadillac Blue Engine Paint 12 oz Aerosol
- Buff Motor 3/4 hp 1800RPM
- 2 5/8" 0-100 psi Carbon Fibr fuel press gauge(M)
- Resistance Spot Welder Spare Tips One Pair
- Nozzle Ceramic Set 1/4 Inch
- Standard Mig Starter Kit
- 8" Stainless Steel Locking Ties (8 pack)
 |
Full chrome outer style steel wheel as used on 1968-1969 Ford Mustang, Torino and Fairlane. Quality accurate reproduction of the original chromed wheel. Wheel size is 14"x7" with the stock 4-1/8" backspace. This is a special order wheel and is not returnable. Configuration is 5-lug with a 4.5 inch bolt pattern. Fordisc brake applications. Made in the USA. |
 |
Eastwood's yellow ultra-high-molecular-weight plastic mallets stretch and form sheet metal. Screw secured head captures handle within for proper fit and allow the head top to beused for forming. Made in the USA. |
 |
When superior atomization and build quality are of the highest importance - Demanding Professionals Demand Sata. This gun can be used to apply heavy primers to color and clear coats. The Sata Mini Jet HVLP gun includes instructions, a 1.0mm nozzle set with special air cap forfiner atomization (needed for spot repairs) and aluminum 150 cc cup (about 5 ounces). Requires 3.5 cfm at 29psi. All guns are backed by a 1-year limited Manufacturer's warranty. |
 |
For smaller diameter (3/16" and 1/4" O.D.) coated tubing, use therolling action tubing bender. It utilizes a free-rolling follower CAM to minimize stretching and distortion when bending tubing. This produces uniform, distortion-free, tight, 180 bends down to a 1" radius. Will not harm protective surface coatings on fuel and brake lines. Comes apart for easy placement over long pieces of tubing. For bench use, a tab is provided on the lower handle. |
 |
Muscle Gloss 1050 square foot system Beige |
 |
Wire Tie Tool- Tightens and neatly trims nylon ties. Much easier than hand tightening. A must for keeping underhood wiring and accessory installations neat. Made in USA. |
 |
A precision pulling tool for use with our stud welders and others with 1" OD grounding ring. Just seat the stud welder in the Dent Killer, bring grounding rods into surface contact and trigger your stud welding gun for.5-1 seconds to attach the reusable "stud". Raise metal with the attached 3:1 lever for exactly the right amount of pull to achieve a level surface. Nylon faced 5-1/2"long support legs adjust from 3" to 7" to span damage & styling lines. Rotate the tool to release the stud. Great for use along creases or in areas without enough overhead clearance to use a sliding hammer. Imported. |
May we also suggest the following products:
