-
CLICK HERE for more information or to Shop online.
- 94 Minute VHS Instructional Video
- Rotating Head Riveter
- 80 Ply Thick Buff 8x1/2 Loose
- 1 Shot Pearlescent Dark Green Met 1/2 Pt
- Flapdisc 40 Grit 4 Inch Diameter 5/8 Hole
- Mobile Body Bench For Powder Coating
- Nitrile Gloves Disposable Medium
- Gravity Feed Paint Gun Stand
- EW 1-1/2HP Motor w/Pedestal
- 2 1/16" 8-18v Artic White Voltmeter blk needle
 |
Nylon Tubing, 6ft., 1/8" dia. Complete with Fittings and Ferrules Only for mechanical pressure gauges up to 200 psi (except fuel pressuregauges). |
 |
This easy to use aerosol etches and primes bare, rustfree metal in one step.Adheres to steel, aluminum, stainless steel, and galvanized steel and is compatable with virtually any paint or auto finish. This self-etching formula bonds better to bare metals than other aerosol primers. It is also a single- stage formula which requires no catalyst, making it even easier to use. Buy 3 or more and SAVE! |
 |
ColortuneAdapter 14mm Long Reach |
 |
Plain Back 2-3/4" Wide Abrasive Paper on 82-1/2'Rolls - Just tear and attach to any length sanding board. Strong backing suitable for hand or air powered sanders in popular grits. |
 |
The unusually high 4:1 shrink ratio of this tubing along with built-in adhesive ensures an air tight, water tight joint sealing out corrosion from wiring connections. Fits wires just under 1/4" (.225") and smaller. Justuse a heat gun, lighter, or match to shrink tubing onto connector and activate adhesive. includes 10 lengths of shrink tube 3" long (enough to seal connections under the hood and car on most vehicles) and complete intructions on package. |
 |
Semi Gloss Clear Powder - Delivers a 50% approximate gloss level. This durable semi-gloss clear isa TGIC polyester formulation that cures at 400 degrees F or 204 degrees C for 20 minutes after flow out occures. Recommended service temperature up to 250 degrees F with peaks up to 350 degrees F. |
 |
Installing or modifying the steering boxes, or just replacing steering box seals? Don't risk damaging the sector shaft or the box castingwith makeshift gear pullers, hammering or excessive heat. This puller with heavy duty center screw and drop forged steel yoke is compact enough to fit confined areas and lasts for years. |
May we also suggest the following products:
